Yosemite Electric Fireplace User's Guide download pdf (Page 14)

14 | P a g e

MAINTENANCE ____________________________________________________________________

Changing Light Bulbs

Disconnect power supply before beginning any maintenance.

1. Light bulbs need to be replaced when you notice a dark section of the flame or when

clarity and detail of the coal effect disappears.

2. Carefully remove the glass front. This is done by lifting the face up and swinging the

front clear of the fire. Care should be taken not to damage the face. Removal of the

face may require two people.

3. Open the base cover panel by unscrewing two (2) screws on it. These need to be

removed to allow the cover to slide down. Figure 7

4. Examine the bulbs to determine which one needs replacing. Remove the non-

working bulb and replace with a new bulb. Hold the socket while unscrewing the

old bulb and while screwing in the replacement bulb. Figure 8

5. Once the bulb has been replaced, replace the base cover panel, screws and the front.

WARNING

• Allow at least five (5) minutes for the light bulbs to cool before touching the bulbs to

avoid burning. Make sure power supply is disconnected.

• This unit requires two (2) Candelabra Incandescent bulbs with an E-12 socket base,

rating voltage 120 volts and rating power 40 watts which are available at most hardware

or Do it Your Self or Lighting store.

Fig. 7 Fig. 8

1 2 ... 9 10 11 12 13 14 15

No comments

Yosemite Electric Fireplace User's Guide Page 14